1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Gateway NV59C Bios Password Removal Guide

Discussion in 'Bios Password Recovery' started by Administrator, Jun 12, 2017.

  1. Administrator

    Administrator Administrator Staff Member

    Joined:
    Apr 6, 2017
    Messages:
    43,413
    Likes Received:
    35
    Steps for Clearing BIOS Password Check

    If users set BIOS Password (Supervisor Password and/or User Password) for a security reason, BIOS will ask

    the password during systems POST or when systems enter to BIOS Setup menu. However, once it is

    necessary to bypass the password check, users need to short the HW Gap to clear the password by the

    following steps:

    1.Power Off the system, and remove HDD, AC and Battery from the machine.

    2.Disconnect the RTC Battery cable and locate the RTC_RST jumper.

    3.Use an electric conductivity tool to short the two points of the HW Gap.

    4.Plug in AC, keeping the HW Gap shorted. Press Power Button utill BIOS POST is finished, then remove

    the tool from the HW Gap.

    5.Restart the system. Press F2 key to enter BIOS Setup menu.

    6.If there is no Password request, BIOS Password is cleared. Otherwise, please follow the steps and try

    again.

    NOTE: These steps are only for clearing BIOS Password (Supervisor Password and User Password).
     

    Attached Files:

Share This Page