1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Packard Bell EasyNote LJ61 Bios Password Removal Guide

Discussion in 'Acer bios Password Remove' started by Administrator, Jun 12, 2017.

  1. Administrator

    Administrator Administrator Staff Member

    Joined:
    Apr 6, 2017
    Messages:
    46,157
    Likes Received:
    46
    Packard Bell EasyNote LJ61 Bios Password Removal Guide

    Steps for Clearing BIOS Password Check

    If users set BIOS Password (Supervisor Password and/or User Password) for a security reason, BIOS will ask

    the password during systems POST or when systems enter to BIOS Setup menu. However, once it is

    necessary to bypass the password check, users need to short the HW Gap to clear the password by the

    following steps:

    1.Power Off the system, and remove HDD, AC and Battery from the machine.

    2.Open the back cover of the machine, and remove the Modem Board

    3.Disconnect the RTC Battery cable and locate the G1 jumper.

    4.Use an electric conductivity tool to short the two points of the HW Gap.

    5.Plug in AC, keep the short condition on the HW Gap, and press Power Button to power on the system till

    BIOS POST finish. Then remove the tool from the HW Gap.

    6.Restart system. Press F2 key to enter BIOS Setup menu.

    7.If there is no Password request, BIOS Password is cleared. Otherwise, please follow the steps and try

    again.

    NOTE: These steps are only for clearing BIOS Password (Supervisor Password and User Password)
     

    Attached Files:

Share This Page